- 註冊時間
- 2006-7-20
- 最後登錄
- 2018-6-6
- 在線時間
- 1075 小時
- 閱讀權限
- 50
- 積分
- 546
- 帖子
- 192
- 精華
- 0
- UID
- 11156
|
回復 3# 的帖子
請問這 TALON 90 電變油門行程校正是否有所不同?
OPERATION
The Castle Talon ESC will not provide power to the motor when first powered up. The ESC must receive a low throttle signal to arm.
Follow this initialization sequence to operate the motor.
1.Turn your transmitter ON and set the throttle stick to mid throttle.
2.If you are using an external BEC or radio battery and your red power wire on the throttle lead is disconnected, power the radio receiver in the RC vehicle.
3.Connect the main power battery to the speed controller. The ESC will make a chime and then a sequence of beeps. Count the number of beeps and make sure it matches the number of LiPo cells that were plugged into the unit.* The speed controller will remain disarmed and will not operate the motor until it receives the zero throttle command from the receiver.
4.When you are ready to fly, move the throttle stick to the lowest position on your transmitter.
5.The Phoenix will play the arming tone through the motor to indicate that it is armed.
說明書裡有提到 "自動油門校正", 請問這該如何配合啊?
Note: if auto-calibrate throttle (default throttle setting) is selected, always restrain vehicle and run throttle to full power prior to flight to allow ESC to recognize the full throttle signal. |
|
發表於 2012-12-17 09:24
分享
收藏
發表於 2012-12-17 09:53
