碳纖維徹側板總算上架

飛行公仔

Upper frame came assembled as shown.

飛行公仔

Tail pulley drive system pre-installed with bearings.

飛行公仔

Front view. Notice the nice blue anodized bling washers on all screws.

飛行公仔

First step involves attaching upper with lower frame with these screws. The screws came out of the bag as shown. Pieces already pre-assembled so there are no mistakes which screws goes where.

飛行公仔

Installing the aluminum motor mount.

飛行公仔

Remove these 3 screws to mount the carbon receiver plate.

飛行公仔

Receiver plate installed.

飛行公仔

Assembled frame top view.

飛行公仔

Rear view.

飛行公仔

Left bag contains CCPM linkages, right bag contains servo mounting tabs and screws.

飛行公仔

From box to finish in 20 minutes!

飛行公仔

Very well built frame.

飛行公仔

Just like the T-Rex kits, a bag of spare hardware is included.


謝謝Steph280國外貼圖分享!

peter0406

所以接收器是放在機頭的斜架碳纖板上！這樣不錯用，若要更換或修理伺服器時拆裝方便，伺服器的安裝還要等Steph280大大PO出來看看，原廠說明書的立體透視圖給它有一點不太懂，好像舵角片的方向怪怪的，還是看到完成照會比較清楚！另外側板上連伺服器線路榜束帶用的孔位都預設好了真是面面俱到 物超所值許許多多

steph280

我原本打算接收器放在機尾下部, 這樣離馬達/電變器最遠, 以防干擾!

我研究了一下, 看來鋰聚放在斜架碳纖板上應會讓小暴龍有最好的翻滾動作.　因為重心(CG)提高到直昇機的中央點. 所以不會有頭輕腳重的感覺.

到時全部裝好了再po給各位大大指教.

因某種原因, 討論移到了這裡: http://www.rcgroups.com/forums/showthread.php?t=401642

還有另外兩點值得一提的優點:　碳纖板有洞讓培林座能準確的裝在機身上.