2.4 控朋友留意尾巴

mugen511

可是如果伺服器舵片在微調是中立點且SUB TRIM也是中立點的時候 舵片無法呈90度的垂直 那怎麼半呢

OSOS

可用圓形伺服器舵片，自行挖掘洞哦！

hrmo

好訊息,謝謝提醒大;家..

電動漢堡

嗯~有道理!
所以機子試飛完成後~最好在做一次對頻動作!
讓中立點B也變成中立點A的意思~這樣假使有狀況~
F/S抓取的點~才會跟實際預設的更接近!
(不對請指正)

chenghao513819

感謝分享!!~~~~~~~~~~~~~~~~~

hyc

阿。。。這個好，又學習了。。。感謝大大

hyc

再對一次頻是很重要，我趕快再對一次。。。。。

X3710

重新對頻  這真是很重要的  最近發見我的600N上的 亞拓750的要比  600ESP上的亞拓700陀螺儀快喔

sanjose

GY401's rudder neutral point can be reset by switching GY401 between AVCS and normal modes.
I always do this before taking off.
Can GP750 do this?


‧Rudder neutral signal memorization methods
[Method 1] When the gyro power is turned on, the transmitter rudder signal
automatically received at that time is assumed to be the neutral signal and
is memorized. The gyro is normally used in this state.
[Method 2] Rapidly switch the transmitter sensitivity switch between the
AVCS and normal modes at least 3 times at a 1 second or shorter internal,
then set the switch to the AVCS mode position. The monitor LED flashes
instantaneously and the rudder signal is memorized. If the trimmer was
moved during flight, the memorized neutral position can be updated to the
current neutral position by repeating this operation. When performing this
operation, land the model and hold the rudder stick in the neutral position.

72.530

~感謝大大分享~