10-21-2008, 12:32 PM Join Date: Dec 2006
Location: Irvine, CAlifornia
Quote:
Originally Posted by tick77  this servo is being sold as a tail rotor servo as well. so yes you can use it for that. I just had a bad wreck with servo doing a caos close to the ground and the servos didn't get phased by it. metal gears all around very smooth transition and plenty of power for a price of $67 a pop. it can't be beat. I took a look inside and the circuit board and solder joints are well made. no sloppy work at all. ( I used to work for SONY electronics in greensburgh PA.) I know a good solder joint when I see one.  definetly recommend these servos.and as far as I'm concerened this post will probably never get old. only more popular....:-) |
Any further update on these servo?
) , but I'm well over 70 now with 2 crashes. no signs of wear, they center perfectly and now I'm thinking about buikding a second 600E soon, as a back up for when I go to air shows. I'm just affraid that the second one will become a shelf queen 
.